Menu Close

DIY – CARD WITH WASHI TAPE PATTERN

DIY card with washitape | designoform.com

If I don’t remember wrong this is the blogs first DIY using Washi tape. It’s a pretty simple one but you need a bit of patience.

/// Om jag inte är helt fel ute nu så tror jag minsann att detta är bloggens första DIY med Washi tape. Det är väldigt enkelt med kräver lite tålamod.

Other than that you’ll need:

→ Washitape with a striped pattern
→ A pair of scissors
→ A card (If you are using Washi tape that are black and white like I did you get the best result with a white card since the Washitape is a bit transparent)
→ A piece of regular paper

Till detta behöver du:

→ Washi tape med ränder
→ Sax
→ Ett kort (Om du använder svart och vit Washi tape som jag så får du bäst resultat med ett vitt kort då Washi tapen är lite genomskinlig).
→ Ett vanligt papper

And this is how you do it:

First you cut a stripe from the regular paper as wide as the Washi tape. Then you draw a line in a 60° angle.

/// Börja med att klippa ut en bit ur det vanliga papperet som är lika bred som din Washi tape. Sedan ritar du ett streck som är i 60° vinkel.

DIY card with washitape | designoform.com

Cut along the line. Then fold like the picture shows.

/// Klipp längst med linjen och vik som bilden visar.

DIY card with washitape | designoform.com

Then you cut again and unfold. Now you have a template for the Washi tape.

/// Klipp sedan igen och vik upp. Nu har du ett mall till Washi tapen.

DIY card with washitape | designoform.com

DIY card with washitape | designoform.com

Now it’s time to start making the pattern. All pieces are the same, you just rotate them.

/// Nu är det dags att börja med mönstret. Alla bitar är likadana, vi bara roterar dem.

DIY card with washitape | designoform.com

I started in the middle and worked my way out to the sides. Some tips along the way: When you fasten your pieces, do it so that they still are a bit loose, because you may have to go back and move them a bit later. At the same time don’t be too meticulous. A small gap won’t show when the card is finished.

/// Jag började i mitten och arbetade mig utåt. Några tips längst vägen: När du sätter fast dina bitar låt dem vara ganska lösa, för det kan vara så att du behöver gå tillbaka och ändra och flytta om lite. Men var samtidigt inte allt för noga för eventuella småluckor kommer inte att synas i slutändan.

DIY card with washitape | designoform.com

When the pattern is done, you cut along the edges of the card to remove the leftover Washi tape. And you are done!

/// När du är färdig med mönstret klipper du längst efter kanten på kortet för att ta bort all överbliven Washi tape och du är klar!

DIY card with washitape | designoform.com